Prep Wood Floor For Peel And Stick Tile

Install peel and stick vinyl floor tiles on plywood however if the wood subfloor is a non positively glued plywood floor peel and stick vinyl can be placed directly on this floor without a protective film or insulating underlay.

Prep wood floor for peel and stick tile. Peel and stick tiles will bond to bare plywood but you must ensure the plywood is secure and clean first. Peel and stick tiles can be installed over almost any type of subfloor though it is important to properly prepare the floor first to avoid problems with your tile flooring. Prepare a wood subfloor for tile a successful tile installation project requires a level surface. Install 1 4 in 0 64 cm luan plywood over a wood subfloor.

However self stick tile also requires a precise eye when setting the first tile and those in the first row adjoining it. Wash waxed floors with a cup of ammonia in a gallon of warm water to remove all traces of the wax. When installing over existing oriented strand board osb an underlayment must be added between the osb and the tiles. Self stick vinyl tile also called peel and stick tile is a do it yourselfer s dream material.

Get enough 1 4 in 0 64 cm luan to cover the entire floor in your room and apply a thin layer of flooring adhesive on the back side. Check for dips in the floor by sliding a 4 foot to 6 foot straight edge in different directions all around the room. This is due to osb s tendency to swell and warp. Apply a thin layer of leveling compound along the plywood seams and then allow it to dry and sand the seams smooth before laying the tiles.

Luan plywood has a smooth surface and makes it easier to lay your planks on top. It requires only basic skills minimal time and a few tools. If you find hollows and valleys you must fill them with a self leveling underlayment. Plywood is the best way to ensure the tiles will bond tightly and that the old floor won t telegraph through the new tiles.